Hello, i have a switch with sxos and ofw 4.0.1, long story short, i triggered an update flag on 6.2 emunand, and decided to install 7.0.1 on sx 2.6.1 (i'm on hidden partition emunand)
So i did the standard procedure of downloading the fw, and tried to install it via ChoiDujourNX, first time i selected exfat install and left the autorcm thing on.
when i reeboted the switch i didn't get anything past the sxos Splashcreen, so what i did was completely wipe off my sd card and start over, i recreated hidden emunand on 4.0.1 which is working just fine, and then tried updating to 7.0.1 again, however, this time i got adviced to update in non exfat mode, and disable the autorcm mode in choidujour, since i was told that could cause problems since i'm updating emunand.
After updating, i rebooted the switch and nothing has changed, after the sx os logo, nothing appears on screen, not even a battery logo.
the original nand is on 4.0.1 and still works properly if i boot ofw
What am i doing wrong? can't seem to make this emunand work properly
So i did the standard procedure of downloading the fw, and tried to install it via ChoiDujourNX, first time i selected exfat install and left the autorcm thing on.
when i reeboted the switch i didn't get anything past the sxos Splashcreen, so what i did was completely wipe off my sd card and start over, i recreated hidden emunand on 4.0.1 which is working just fine, and then tried updating to 7.0.1 again, however, this time i got adviced to update in non exfat mode, and disable the autorcm mode in choidujour, since i was told that could cause problems since i'm updating emunand.
After updating, i rebooted the switch and nothing has changed, after the sx os logo, nothing appears on screen, not even a battery logo.
the original nand is on 4.0.1 and still works properly if i boot ofw
What am i doing wrong? can't seem to make this emunand work properly