You'd have to run SafeA9LHInstaller again, with the files you had before, as well as your console specific OTP.bin.
No need to modify anything. I just uninstalled liomajor's workaround, and everything is running smoothly. Just make sure you have the Launcher.dat as well on the root of your SD Card.Fantastic !!
meaning it will run on my current A9LH setup,no need to modify anything ?
No need to modify anything. I just uninstalled liomajor's workaround, and everything is running smoothly. Just make sure you have the Launcher.dat as well on the root of your SD Card.
i need to download the original payload_stage1.bin and payload_stage2.bin?
If you followed Plailect's guide, just use those files again, and if you deleted them, you can download them from there again.i need to download the original payload_stage1.bin and payload_stage2.bin?
I keep just getting a black screen with the GW arm9loaderhax.bin, I have tried as both a chain loaded Luma payload and just putting it straight on the root of the card replacing Luma.
I have a N3DS with no screen init a9lh install on a updated sysNAND with no emuNAND present.
Yes I do have a Launcher.dat on the root of the SD card
It's probably the no init. I think GW wants screen init. I'll check, though it's unlikely to matter for me -- I use BootCTR9, and that has it's own screen init code.
When I tried it as a Luma payload I tried that with both the option to force screen init for a boot animation on and off, since on should've been enough to get it to work.
Not necessarily. Just tried running it straight with no init. Gives a black screen as you said. Just tried running it with BootCTR9 and no init, and it works. This is why I say, for a boot manager, I prefer one app that does one thing well. It's not like Luma will brick you or anything, but boot management is not it's primary focus, either.
Have you tried formatting the SD card using Emunand9's No Emunand option?I just tried with a screen init and got it to work with one annoying caveat. It will not auto boot into sysNAND since I have no emuNAND it just goes to a black screen after the Gateway logo has been shown.
The only way to get it to fully work is to hold the L button shortly after it starts booting then force sysNAND mode using the B button at the Gateway menu. Then it boots fine.
How did you remove your emuNAND?I just tried with a screen init and got it to work with one annoying caveat. It will not auto boot into sysNAND since I have no emuNAND it just goes to a black screen after the Gateway logo has been shown.
The only way to get it to fully work is to hold the L button shortly after it starts booting then force sysNAND mode using the B button at the Gateway menu. Then it boots fine.
which launcher.dat version are you using?The only way to get it to fully work is to hold the L button shortly after it starts booting then force sysNAND mode using the B button at the Gateway menu. Then it boots fine.
How did you remove your emuNAND?
4.0a for no nagwhich launcher.dat version are you using?
You'll probably have to use Emunand9 to format it, using the Format (No Emunand) option, to properly remove traces of Emunand.I had a emuNAND on this card when it was in my O3DS but never bothered with a emuNAND on my n3DS . I believe during the transfer I just formatted it in my computer. I'll try removing any traces that might be left behind.
--------------------- MERGED ---------------------------
4.0a for no nag