Not sure what to tell youYeah. I backed up my entire SD card before installing the emunand partition and copied it back after. My stuff isn't showing up on sysnand or emunand.
Not sure what to tell you
Are you booted into CFW when using FBI?can you please help me. I cannot install anything with FBI. always gives errors
Are you booted into CFW when using FBI?
that doesn't answer my question...I can only use CakesFw. I couldn't use any other one. I am on N3ds
that doesn't answer my question...
Then start FBI and try to install stuff? If yes, then tell me what the errors areYes. I boot to cfw using cakesfw
Then start FBI and try to install stuff? If yes, then tell me what the errors are
This is a problem for the FBI thread"Faild to start am services". I got it with every FBI installer I tried
You formatted sysNAND then...There are two folders on part of my SD card but only one on the backup. One is 16mb and the other is 2 gb.
you wouldn't have two folders if that were the caseI don't think I did. I just formatted the SD card using emunand9 and then it copied sysnand onto the sd card.
If you unlinked then yeah that way... there is no way (that I know of) that doesn't involve user inputIs there any way it could have been formatted?
Ok, so apparently I have already installed Themehax. It appeared to be successful, but I can't seem to get the HBL to boot when pressing L after turning the system on. Do I have to try installing again?Step 10
Install Themehax on sysNAND
Step 11
- boot your 3ds up
- start CIAhax
- start the themehax installer, this was included with the homebrew starter kit you downloaded earlier
- follow the onscreen instructions to install themehax for your system version
Install autoboot CFW
- in the release of the CFW that you decided to use should be a .3dsx file,
- Congrats you have an autobooting CFW!