Wiikey chip help...

Discussion in 'Wii - Hacking' started by battousai8728, Jul 3, 2007.

Jul 3, 2007

Wiikey chip help... by battousai8728 at 4:32 AM (919 Views / 0 Likes) 2 replies

  1. battousai8728
    OP

    Newcomer battousai8728 Member

    Joined:
    May 1, 2005
    Messages:
    22
    Location:
    Clifton, New Jersey
    Country:
    United States
    I installed my Wiikey with wires months ago. Point 4 came off today, as I was case modding the Wii (I probably should've done it all together, but I guess I made a mistake). Most likely I can solder it again (I don't think the pad's burnt). But if I have to solder it to the drive chip, can someone help me out with a visual guide of where the chip is and where I have to solder it to? I know it's even harder to do than the point, but I don't want to buy another Wii.
     
  2. battousai8728
    OP

    Newcomer battousai8728 Member

    Joined:
    May 1, 2005
    Messages:
    22
    Location:
    Clifton, New Jersey
    Country:
    United States
    Also, is that metal casing on top of the DVD part really necessary? It seems a little tight in there with the XCM black case and was wondering if I can just choose not to put it in there.
     
  3. dohclude

    Member dohclude GBAtemp Fan

    Joined:
    Oct 12, 2006
    Messages:
    384
    Location:
    The Patch Walks!
    Country:
    United States
    the metal casing is not absolutely required, you can remove it if you really really want to. Here is a couple of pics of wired / repair installs I've done, maybe this can help you. Good Luck!

    [​IMG]

    [​IMG]
     

Share This Page