Hacking WII CHIP WITH WILL CLIP

[skylinelks]

I have purchased http://www.modchipcentral.com/store/D2Pro9...iver-p-125.html
when i install my wii clip into my wii, the red light do not go away,cannot inject any disc.
Then i look @ this http://www.wii-clip.com/
WII-CLIP V4C
It is soldered all the points.but my wii chip are only soldered c,d,e,f,g,h,j,gnd,3v3,clk
and i have gc2-d2c
what should i do right now?
My package also come with a little cable..what is it for?
Thanks

 

[tatumanu]

before putting your wii clip with d2pro9 in your wii remember that you have to put the sticker on the bottom and when putting the clip on your board aplly some pressure to it then before closing your wii remember you have to put the card with the hole on top of the clip.

Maybe you cant eject cause you forgot to put the cable that connects the front of the wii to the rest of the wii (that controls all the buttons).

the little cable that comes with it is for soldering... its for region free. but its optional, if i was you i wouldnt do it cause you can use homebrew called geckOS to boot games from other region other than yours.

hope it helps

 

[skylinelks]

i did put the sticker.
I have not put my wii back yet.
It keep opening until i know it works perfect.
i did not use the front button for inject, but i use the button inside my wii.
when i take off my chip, it works fine.
If i do not solder the region free wire, can i play japanese game?

 

[hippyharry]

what sticker are you's talking about?

 

[gratefulbuddy]

My package also come with a little cable..what is it for?
Thanks

The flat cable is used to connect to the d2prog for the purpose of updating. The cable goes in the white connectors of the D2Pro and the D2Prog respectively.