Hacking Question Switch 4.10 after Updating with ChoiDujour102 Blackscreen

[Baked]

Switch Firmware is on 4.1.0
everytime i tried to manually update AMS emummc with ChoiDujour102 to 8.1.0
it's fine with Kosmos/Atlas Logo then Sept Logo then AMS logo and after that it stays at Blackscreen.

I don't know anymore what to do.

i followed everystep at switch.homebrew.guide
- SD Card formatted with 1 Partition Fat32 and 1 Partition without for emummc
- flags Folder with the self created hbl_bis_write.flag
- Wiped already many times SD Card clear and and loaded my Untouched NAND backup

but it's still the same everytime i try to Update it.

 

[dxxshore]

Did you wait a little longer, did you install wrong format of the update, make sure your using newest kosmos and pegascape. I only say wait first, the first time I loaded higher firmware on my switch, I wasn't using exfat and it took a while to get the switch emblem.

 

[Baked]

Did you wait a little longer, did you install wrong format of the update, make sure your using newest kosmos and pegascape.

i did download the newest kosmos and pegascape
i tried first the right update without exfat and got after all the logos the blackscreen waited always around 20 mins but nothing happen
so i wiped everything from the sdcard and loaded clean nand backup.
Then i tried the update with de exfat also no luck the samething -> blackscreen

Should i try to update from 4.1.0 to 7.0.1 and then 8.1.0?

 

[dxxshore]

Have you used choidujour to update sysnand to exfat 4.1.0, then formated card to exfat, make clean emunand, load it update it making sure auto rcm isn't on.

 

[Baked]

Have you used choidujour to update sysnand to exfat 4.1.0, then formated card to exfat, make clean emunand, load it update it making sure auto rcm isn't on.

CFW sysnand or stock sysnand?

 

[dxxshore]

You need cfw to run choidujour, make sure autorcm is off, and that you are using 4.1.0 update, that gets your stock to read exfat cards.

--------------------- MERGED ---------------------------

Again can't stress enough no autorcm if you're running ipatched unit using pegascape