Hacking Hardware Solder on anchor are a little thick and bend the shield on CPU is this a problem?

[Psygnosis]

After soldering with success a picofly I've notice this...I can't place correctly the metal shield on cpu at the point of the anchors soldered on the frame.
Could this be a problem?
Thank you so much

 

[thesjaakspoiler]

Check that the metal casing is flat on the center of the CPU.
Then it should not matter much.
If there is some (partial) air gap on center of the CPU, it might overheat and shut down.

 

[Psygnosis]

Check that the metal casing is flat on the center of the CPU.
Then it should not matter much.
If there is some (partial) air gap on center of the CPU, it might overheat and shut down.

Thank you so much, so it's better if I start again and check the metal plate? because I don't know how to check this