I'm not 100% sure on what you'll need to go about this, but that could very likely fix your problem if you know what firmware that backup was on, and your current fuse count. If you're sure the fuse count is 7, then that firmware will have to be 6.1.0 at the most to work. As a last attempt, you could try retrieving your PRODINFO and rebuilding your NAND for 6.1.0, again I'm not sure of what you'll need, just pointing in what I think is the best direction.I did not
Were you backing up or restoring from SX? Either way you should restore with Hekate, just charge your switch enough and Hekate should work even with a wrecked NAND.Well I think I'm doomed....I was restoring my nand via sx and I think my battery died before it finished.... now it won't turn on at all....ugghh
Well I think I'm doomed....I was restoring my nand via sx and I think my battery died before it finished.... now it won't turn on at all....ugghh