What about the cable from the mosfet to the chip? Should it also be copper and short or does it matter?Ensure the CPU flat cable is properly attached and well-soldered.
If you use a single MOSFET, ensure the wires are short and thick. You need at least 0.2mm diameter copper wires, like here:
Silver cableWhat about the cable from the mosfet to the chip? Should it also be copper and short or does it matter?
Silver cableWhat about the cable from the mosfet to the chip? Should it also be copper and short or does it matter?
any length / thickness, thin is better, less chances to break padWhat about the cable from the mosfet to the chip? Should it also be copper and short or does it matter?
I was wondering what's the use of talking about installation, cable length and thickness when we don't have the firmware that is the most important part?
My man really gave a big list lolLow cost to do?
Most parts on hand?
Parallel Processing?
Eagerness/Excitement?
Discussion doesn’t hurt anything?
Positive outlook that it will happen soon?
Avoid long delays on unique parts?
Filling the time with something useful while we wait?
Divergent thinkers don’t follow the pack?
Better w/ Hardware than w/ Software?
General curiosity?
Other than that, I have no idea. Baffling, really.
It is of no use to us.I was wondering what's the use of talking about installation, cable length and thickness when we don't have the firmware that is the most important part?
If I'm not wrong, It's possible to run Hekate and Linux/Android ATM. The problem is we don't have the firmware for running Atmosphere.I was wondering what's the use of talking about installation, cable length and thickness when we don't have the firmware that is the most important part?
well i agree with all of you....i said rubbish i totally give up.........................long live the hypocrisyI was wondering what's the use of talking about installation, cable length and thickness when we don't have the firmware that is the most important part?
Please just buy the flex cable it's like 7 bucksWhat about the cable from the mosfet to the chip? Should it also be copper and short or does it matter?
It takes a loooooooooooong timePlease just buy the flex cable it's like 7 bucks
are there files for the Fpc connector from the Hwfly chip so we may be able to get them made ourself?I
same here thats why im gonna do it with cables like @rehius showedIt takes a loooooooooooong time![]()
A few reasons.Good luck, this may seen like a stupid idea but why not compare the original firmware we got that was I'd locked (assuming it can boot atmosphere) compare it to the Ubuntu only one. Find where the sd payload is in the Id locked one and copy it over?
Note I'm not a programmer and have no idea I'd this would even work
are there files for the Fpc connector from the Hwfly chip so we may be able to get them made ourself?
that whay we could get them made at jlcpcb orso with even faster shipping and prob cheaper then aliexpress ?