yes, I understand this from reading all the 78 pages
i wish mena/phenom could dropby this thread also
also forewarning, anyone attempting to try this.
backup your nand first, boot0,boot1 from a normal chip (hwfly or sx)
I did some stuff earlier and switch won't boot hos even with the pico is not connected
1. first install success, can get to hekate, get boot hos by pressing reboot to ofw
2. dumped boot0, boot1 with picofly
3. restored a mariko (lite) boot0, boot1 i had from a donor
4. picofly took a few seconds longer to glitch and call hekate
5. tried to reboot to ofw (normally it would start ofw) but now it is = BLUESCREEN
6. restored boot0, boot1 that i dumped from pico, no more bluescreen BUT
7. switch will boot hekate fine, but will blackscreen when restart to ofw, or even if the chip /picofly is removed
will put back a hwfly chip and restore boot0, boot1 from there maybe it will be fixed
i'm calling it softbrick for now, boots hekate, but no longer boots ofw even if the chip is removed.
so again, warning to all, do not trust the boot0/boot1 dump or any other dump made from picofly , will install a hwfly chip tomorrow (it's 11PM here +PST)