Homebrew New Luma update settings when installing A9LH?

[mrvandal]

when installing with new version of luma3ds version 6.0.1 "SysNAND is updated" and "Force A9LH detection" do not appear. the options for 6.0.1 are
( )Autoboot SysNAND,
( )Use SysNAND FIRM if booting with R (A9LH),
( )Use second EmuNAND as default,
( )Enable region/language emu. and ext. .code,
( )Show current NANAD in System Settings,
( )Show GBA boot screen in patched AGB_FIRM,
( )Display Splash Screen before payloads,
( )Use a PIN.
Which of these options should be checked when configuring Luma3ds section 3 part 5 on Plailect's guide? thanks.

 

[KunoichiZ]

Just use v5.5 until the guide has been updated to show the recent Luma config screen changes and then update to v6.0.1 after you finish the guide.

 

[mrvandal]

Just use v5.5 until the guide has been updated to show the recent Luma config screen changes and then update to v6.0.1 after you finish the guide.

I've already installed 6.0.1 and made it to section 3 of part 5. How could I remove the current version and install 5.5?

 

[olec04]

@Bortz plz move thread to flashcarts and cfw

 

[KunoichiZ]

I've already installed 6.0.1 and made it to section 3 of part 5. How could I remove the current version and install 5.5?

Replace the arm9loaderhax.bin file from Luma v6.0.1 with the one in v5.5.

 

[nooby89]

Why you just don,t say what is the new thing ?
You need :
( )Autoboot SysNAND,
( )Use SysNAND FIRM if booting with R (A9LH),
( )Enable region/language emu. and ext. .code,
( )Show current NANAD in System Settings,
( )Show GBA boot screen in patched AGB_FIRM,

 

[ksanislo]

when installing with new version of luma3ds version 6.0.1 "SysNAND is updated" and "Force A9LH detection" do not appear. the options for 6.0.1 are
( )Autoboot SysNAND,
( )Use SysNAND FIRM if booting with R (A9LH),
( )Use second EmuNAND as default,
( )Enable region/language emu. and ext. .code,
( )Show current NANAD in System Settings,
( )Show GBA boot screen in patched AGB_FIRM,
( )Display Splash Screen before payloads,
( )Use a PIN.
Which of these options should be checked when configuring Luma3ds section 3 part 5 on Plailect's guide? thanks.

If you want SysNAND to be the default, check the top option for autoboot sysnand... otherwise your emunand/rednand will be the default... Hold down the L bumper to boot the alternate.

The rest of these can all be left unselected, since they don't make much of a difference in a basic setup.