Gaming Netgear Router help

[iYoshi-]

Yeah so i got a new router, Its a Netgear DGN2000, It didnt come with a disk, so i installed it using the setup wizard, everything went fine, it detected internet and the wireless is working, but it wont let me connect to the net, even though it detects it...

Help plz

BTW posted this in the right spot?

 

[Rydian]

This is the right spot. In your start/globe menu, go to the "run" command. If you're on vista/7, you'd use the little white box near the bottom. Type in "CMD" and press CTRL+SHIFT+ENTER.

In the black box that comes up, type "ipconfig" and press enter. It'll list a series of four numbers as your "default gateway". Write those down. Go open any web browser, and enter the four numbers (like 192.168.x.x) into the address bar, and press enter.

A login box should come up. The username should be "admin" or blank, and the password can be anything from "admin" to "administrator" "pass" to "password" or "password1", or something else if you've set it differently. Ask whoever set up the router what the password to get into it is, or check this page.
http://www.phenoelit-us.org/dpl/dpl.html

Then you'll be in the manual settings of the router. Are you on cable or DSl?

 

[iYoshi-]

Yes yes ive done all that, i did it manually following steps my friend has done, and used the setup wizard.
I click Connection Status and it says its connected and all good, Yet it wont let me onto the net.

 

[Rydian]

Again, is it cable or DSL?

If it's cable, is the connection mode on DHCP?
If it's DSL, is it on PPPoE and did you input the username and password for your ISP, and did you also log into the modem and set it to "bridge ethernet" mode instead of PPPoE?

 

[iYoshi-]

Ho crap i forgot to say, yup DSL, username and pass done and with that bridge ethernet, no option for it buddy

 

[papyrus]

Check your Ip address when connected directly to the modem first, and make sure they are not the same with the Ip address of your router. If thats not the case, reset your router, do a manual install (setting the connection to PPPoe, input username and pass) and after that do a powercycle for 1 min. If all of that doesnt work, you may try upgrading the router's firmware, reset and then the manual install.

 

[iYoshi-]

Nothing i do seems to work for it.
Ill try again tomoz, thanks for the help guys