I was working on a modchip installation - the system turned on after I finished grinding down to the dat0 point. I was having a very hard time getting solder to bind to the dat0 point, I was having to clean and retry, and clean and retry. Eventually, I had been working on it for quite a while to no avail, I tested the motherboard again and it won't turn on anymore. The only things that have come into contact with the board are my iron, low-temp solder, flux, alchohol, and solder mask. My best guess is that I somehow damaged something with the heat of my iron, but I don't know what? Has anybody else had this problem before?
Last edited by thebroodian,