Jtagging question.

Discussion in 'Xbox 360 - Games & Content' started by Cermage, Feb 13, 2010.

Feb 13, 2010

Jtagging question. by Cermage at 6:29 AM (899 Views / 0 Likes) 5 replies

  1. Cermage
    OP

    Member Cermage GBAtemp Advanced Maniac

    Joined:
    Dec 2, 2007
    Messages:
    1,702
    Country:
    Australia
    so after selling my banned arcade, i've picked up another 360 off ebay, rrod mind you. and i plan to jtag it to get all that homebrew goodliness.

    so after flashing the nand and installing everything, is it necessary to keep the soldered LPT cable inside? i don't see any reason why it would need to stay inside, but i'm just making sure.
     
  2. quepaso

    Member quepaso GBAtemp Fan

    Joined:
    May 4, 2008
    Messages:
    438
    Country:
    United States
    No, you remove the lpt cable after a successful flash.
     
  3. wes11ph

    Member wes11ph GBAtemp Fan

    Joined:
    Jul 1, 2009
    Messages:
    455
    Location:
    basement lvl-249
    Country:
    Afghanistan
    if you successfully do install xbr. you can remove it now.
     
  4. Cermage
    OP

    Member Cermage GBAtemp Advanced Maniac

    Joined:
    Dec 2, 2007
    Messages:
    1,702
    Country:
    Australia
    ah ok cool. what about updating xbr? do you need to redo the entire process or is there a easier method now?
     
  5. FAST6191

    Reporter FAST6191 Techromancer

    pip
    Joined:
    Nov 21, 2005
    Messages:
    21,712
    Country:
    United Kingdom
    Before you might have needed something nowadays software based flashing methods work very well. Obviously keep the dumps you make in case you have to redo it but software has you covered.
     
  6. steve-p

    Member steve-p GBAtemp Advanced Fan

    Joined:
    Apr 13, 2009
    Messages:
    503
    Country:
    United Kingdom
    if you use reboot then the resistors or diodes must stay.
     

Share This Page