Issue with NSP installation?

[evilone]

Hello,

I have a problem with my Erista Switch 13.0 and AMS 1.2x. When i connect my switch with Tinfoil over USB than installation is often aborting, first seconds transfer is blazing fast and after it stops or nearly stops and then quiet often i get a time out error.

Could it be possible that the Nintendo USB-C Cable is not good for Datatransfer? (with Goldleaf i had the same issue, with DBI aswell).

Thansk in advance

 

[trepp0]

could be a bad nsp, have you tried other sources, the stock cable should be just fine for data transfers.

 

[evilone]

Hello,

Thanks for your answer, yes, i tried it with several, but always the same. When i use TinFoil then it starts really fast for the first 500-1000MB transfer and then it goes down to zero and in the end slowly i comes up again.
Same issue with DBi except here you can see the transfer rate, but always stops on large files and gets a time out.

Perhaps Bad Driver? I have currently the Tinfoild_Driver.exe installed.

 

[trepp0]

Hello,

Thanks for your answer, yes, i tried it with several, but always the same. When i use TinFoil then it starts really fast for the first 500-1000MB transfer and then it goes down to zero and in the end slowly i comes up again.
Same issue with DBi except here you can see the transfer rate, but always stops on large files and gets a time out.

Perhaps Bad Driver? I have currently the Tinfoild_Driver.exe installed.

intresting, what happens if you put the .nsp file on the sd card and installing using the switch itself? also, i know its strange but maybe update sigpatches?

 

[evilone]

@trepp Never did that before.. but when i transfer files to the switch mostley using FTP.
What would be the best application to install NSPs on the switch? Tinfoil?

 

[Rune]

@trepp Never did that before.. but when i transfer files to the switch mostley using FTP.
What would be the best application to install NSPs on the switch? Tinfoil?

My problem wasnt the same as yours, but I had problems installing games with Tinfoil over USB and switched over to Awoo Installer, and everything was fine.
My issue was that my games were installing, but then they would refuse to load and give me an error. Some games worked while some didnt, and I couldnt figure out why. DBI was giving me the same issues as well. But it was only with Awoo Installer that everything worked.
Give Awoo Installer a try and send the NSPs using NS-USBLoader from your computer.

 

[evilone]

@Rune

Thank you for this Tip, i did already, but for some reason NS-USBLoader had problems with the USB: Connected or Disconnected status, i tried to transfer but befor it starts it aborted already

 

[Rune]

@Rune

Thank you for this Tip, i did already, but for some reason NS-USBLoader had problems with the USB: Connected or Disconnected status, i tried to transfer but befor it starts it aborted already

Maybe its the cable, or maybe the port you are using?
Try another cable and a different USB port on your PC.

 

[evilone]

@Rune yes, i thought this as well, but when i use the USB-A > C cable, it has the same effect than a 100W USB-C > C cable which is directly connected to the PC, but the effect is the same.

 

[burhansalih]

use DBI never had an issue..always used to get those kind of issues with NS-USBloader.