I keep getting solid blue and cyan lights on my switch after hwfly installation, and the switch boots to ofw, tried soldering everything three times, all reading are right, but the chip doesnt even retrain, any solutions?
Hwfly oled not working
- Thread starter ABDULSALAM-ALGHAMDI
- Start date
- Views 2,905
- Replies 11
- Likes 1
I already flashed it with 0.7.1 hwfly nx, and got these lights, also tried other firmwares from the reseller in Aliexpress, they all give my one purple blink and the switch boots to ofw
Dat0 or CLK will most likely be your issue. When OFW boots its usually dat0 not soldered correctly. Be careful not grounding clk as you can corrupt nand and get purple screen. Diode mode usual readings are 600-750.
But readings are fine, can it happen even when readings are correct?
My switch OLED has turned into a purple screen,What should I do?
Remove flex + wires and see if ofw boots. If not then clk prolly grounded and nand corrupt or shorted.
Try to reset the chip and run diagnostics, this can be done through SSH console like PuTTY by connecting to the COM port of the chip (more info on hwfly-nx github page). This can give you more info about the problem.
I cannot boot with my hwfly 4.1 oled chip neither, the readings are fine, and I get BAD00110 error (more info on my thread). Now I'm waiting for a new chip to arrive to try again. Did you manage to try with a different chip as well?
I cannot boot with my hwfly 4.1 oled chip neither, the readings are fine, and I get BAD00110 error (more info on my thread). Now I'm waiting for a new chip to arrive to try again. Did you manage to try with a different chip as well?
yes, it worked perfectly, i think the reseller sent me a defective one according to sthetix
Similar threads
