Hacking Can't boot to OFW after updating

[greator]

Hello guys, I need help.
Got my v1 patched switch here modded with rp2040. Everything works fine in firmware 16.0.0 using HATS pack.
17.0.0 came out and updated it once a stable version of Hats pack released.
So following the Hats creator advice, I just need to update sysnand and that will update the ofw as well.
It does, but the efuses didn't burn. Still stuck at 18. Now I cant boot to OFW. But I can play around in Sysnand and emunand fine.

What should I do in this case?
I read some posts said that restoring boot0 will help. But my boot0 is from firmware 16.0.0, wont it interfere with the sysnand which is on 17.0.0?

Also, if both sysnand and emunand skip efuses check and burn, why are we updating firmware from sysnand and not from ofw via ota so we can get a proper fuse burn?

 

[greator]

ummm any help pls?

 

[misterion]

You are not in a problem! Just rcm after 12-15 sec of holding the power button. Then update to atmosphere 1.6.2 .
This updates:

An improved solution to the problem that would cause consoles which had previously re-built their SYSTEM partition to brick on update-to-17.0.0 was added.

• In particular, booting atmosphère will now automatically detect the problem and unbrick any consoles which have fallen into this state.

I hope that this was the problem ...! Good luck!