can same one help me with those ripped speaker pads

[mahdi2023]

can same one help me with those ripped speaker pads
i have try to scratch those two ripped pads but as the pcb is multi layer i have found that under those there ripped pads is GND

any solution how can i jump the two cable of speaker to other place

 

[The3rdknuckles]

scratch off the top of the trace lines leading to those pads. Solder a thin piece of bare wire to each trace. Roll up the other ends of the wires not soldered. Cover it up with UV mask. Expose “new” pads.

 

[mahdi2023]

scratch off the top of the trace lines leading to those pads. Solder a thin piece of bare wire to each trace. Roll up the other ends of the wires not soldered. Cover it up with UV mask. Expose “new” pads.

thank for your reply i have scratch those two pad but when i mesure with continuous multemeter they are link to ground those two pad it is normal ?

 

[thesjaakspoiler]

Here you can find the board layers for most models :
https://files.zzattack.org/index.php?dir=img/console/switch

 

[mahdi2023]

Here you can find the board layers for most models :
https://files.zzattack.org/index.php?dir=img/console/switch

very helpfull thank you