Hacking Bluescreen

[Rezek]

Hi Folks,
I know im a Moron but can you Guys help me.
I updated my Switch to 6.1.
Rebooted and couldnt load the payload with the Sx Dongle, injected with Tegra and restored my BOOT 0/1
without restoring eMMC RAW GPP.
Now i cant inject a Tegra or anything its just Blue all way long.
Anything i can do about it ?
Greets

 

[GraFfiX420]

Restore your nand backup, start again, sx os doesn't yet work on 6.2, will be an update incoming as soon as they figure it out/reverse reswitcheds code.

 

[Ashura66]

Restore your nand backup, start again, sx os doesn't yet work on 6.2, will be an update incoming as soon as they figure it out/reverse reswitcheds code.

"I updated my Switch to 6.1."

 

[GraFfiX420]

Ok restore your nand backup and boot 0/1.

 

[Rezek]

I dont get so far.
I cant inject a payload with Tegra.
How do i restore my nand or boot ?

 

[GraFfiX420]

Did you try holding the power button for ~15 seconds?

 

[GraFfiX420]

It sounds like your boot 0/1 don't match the firmware version, but I'm no expert.

 

[GraFfiX420]

So I assume by the lack of a reply that holding the power button for 15 seconds got you back into RCM?

 

[Rezek]

Yes. Hard Reset doesnt Work.

 

[GraFfiX420]

Yes. Hard Reset doesnt Work.

Not sure what to make of this, did you get into RCM?

 

[SaggyBeans]

Before you decided to restore boot 0/1 did you try to boot into sx os using tegra? Was it working with the tegra payload method? Your dongle could have just been dead or something. I’m assuming your backed up boot 0/1 you used was done while running firmware 5.1.0 or something? I would try to get back into your bootloader and also restore your rawnand. I would try plugging in the usb-c into your computer and enabling auto-payload in tegra and just hold down the power button for 15 sec until you hear windows disconnect the device and press power & vol + again to have tegra auto load payload. Hopefully you can get back in and do a full restore.


Also!! If you updated firmware without using choiDoujourNX (which auto enables autorcm) you may have to pop in your jig while you send payload to ensure you’re in RCM mode. Maybe autorcm was removed and your switch is trying to boot ofw and throwing a bluescreen or something.

 

[Rezek]

I tried that im not able to get back into RCM.
And yes i got into SX os Firmware but wasnt able to turn Off autorcm .

 

[GraFfiX420]

Makes no sense, if you're in sx os you're in rcm.

 

[Rezek]

I got into sx os before i restored my boot 0/1.
But then i restored it without my rawnand and since then im Stuck in Kernel blue.

 

[Rezek]

I solved the Problem.
Seems my jig was broken.
Used a Paperclip jig and got into RCM again restored Boot and Rawnand. Now i got a Working 6.1 EmuNand.
Thx Anyway

 

[GraFfiX420]

Lol not sure why the thanks anyway, everyone told you it was working, should have checked your jig right away.