Hey guys I have a Switch that blue screened. Our customer said the unit was never or altered. I am following 'How to Install run any switch firmware unofficially without burning any fuses' guide step by step but I am getting stuck at STEP 8.2: TRANSFER BOOT0. After injecting memloader, when I try to start ums_boot0.ini I get the following error.
BOOT section 'ENTRY'
pc=0x80110000
1zma: Decoding error = 1
[MTC_LOAD] Error during 1zma decompression, got 0 instead of 246400 bytes out!
Has anyone seen anything like this? I have replaced BQ24193 though it's possible it is still faulty? I checked pin 5 voltages for M92T36 and they read correctly.
BOOT section 'ENTRY'
pc=0x80110000
1zma: Decoding error = 1
[MTC_LOAD] Error during 1zma decompression, got 0 instead of 246400 bytes out!
Has anyone seen anything like this? I have replaced BQ24193 though it's possible it is still faulty? I checked pin 5 voltages for M92T36 and they read correctly.