Hello all
I’m new here so forgive me if this has been covered, I did some searching and couldn’t figure it out.
Last week I had a friend who owns a very reputable repair shop install my HWFLY I purchased directly from their store on AliExpress.
When I got it back it booted from power off very very inconsistently. I’d say for every 10 or so boots it would actually get to hekate.
I took it back and my friend verified everything was done correctly. I have attached pictures just in case.
Since getting it back, I can’t get it to boot at all, the hwfly chip turns on breaths purple then flashes green and turns off. I get no image and the screen doesn’t even appear to be on but I can’t be sure of that.
For the record, im very knowledgeable with tech stuff and soldering. I used to work as a soldering tech so I have verified the job was done right to my knowledge. However I have never done an install on a switch like this so maybe I missed something?
I’m running 1.5.5 atmosphere and presumably the newest version of hekate.
Could someone please tell me what to do? Also pretty sure I messed up the micro usb so I may hardwire a usb cable to reload the firmware on the hwfly. But I’d like to check with the experts before I take it apart further.
Anyway if anyone knows why this is happening, I’d love some things to check or repair.
Thanks
I’m new here so forgive me if this has been covered, I did some searching and couldn’t figure it out.
Last week I had a friend who owns a very reputable repair shop install my HWFLY I purchased directly from their store on AliExpress.
When I got it back it booted from power off very very inconsistently. I’d say for every 10 or so boots it would actually get to hekate.
I took it back and my friend verified everything was done correctly. I have attached pictures just in case.
Since getting it back, I can’t get it to boot at all, the hwfly chip turns on breaths purple then flashes green and turns off. I get no image and the screen doesn’t even appear to be on but I can’t be sure of that.
For the record, im very knowledgeable with tech stuff and soldering. I used to work as a soldering tech so I have verified the job was done right to my knowledge. However I have never done an install on a switch like this so maybe I missed something?
I’m running 1.5.5 atmosphere and presumably the newest version of hekate.
Could someone please tell me what to do? Also pretty sure I messed up the micro usb so I may hardwire a usb cable to reload the firmware on the hwfly. But I’d like to check with the experts before I take it apart further.
Anyway if anyone knows why this is happening, I’d love some things to check or repair.
Thanks
Attachments
-
IMG_1905.jpeg112.3 KB · Views: 25
-
IMG_1906.jpeg113.3 KB · Views: 16
-
IMG_1907.jpeg101.7 KB · Views: 18
-
IMG_1907.jpeg101.7 KB · Views: 24
-
IMG_1909.jpeg133.7 KB · Views: 20
-
IMG_1910.jpeg104.1 KB · Views: 24
-
IMG_1911.jpeg114.4 KB · Views: 21
-
IMG_1912.jpeg144.3 KB · Views: 21
-
IMG_1913.jpeg136.5 KB · Views: 22