B9S Update problem(?)

Discussion in '3DS - Homebrew Development and Emulators' started by Random3dsGamer, Jun 5, 2017.

  1. Random3dsGamer
    OP

    Random3dsGamer Newbie

    Newcomer
    2
    0
    Jun 5, 2017
    Gambia, The
    So i tried to update my 3DS to the latest B9S 1.2 to get the Luma3DS Ver. 8.0 but I can't run the chainloader menu while pressing START+POWER to power on the console, or it just skips that part on which I can choose what to launch. Anyway i get directly into Godmode9. Pressing SELECT+POWER takes me to the Luma config menu...
    Can anyone help? Or if there was already someone with this problem in the Forums and I just haven't seen the thread could someone give me the link please? I used https://3ds.guide/updating-b9s.html as an update guide. I'm using the newest SafeB9S installer, newest HBLauncher, have the luma 8.0 on the sd card and the newest Godmode9 files on the SD-Card, the 3DS and HBLauncher 2 runs without any problems. Screenshots of the SD Card are attached (it's in german but i think you'll still get it).
    Thanks in advance - Random3DSgamer
     

    Attached Files:

  2. xelrix

    xelrix GBAtemp Regular

    Member
    138
    81
    Feb 13, 2017
    Malaysia
    Use luma7.1 boot.firm
    Paste in luma8.0 boot.firm AFTER youve finished installing b9s 1.2
     
  3. infinete

    infinete The Temp's cynic.

    Member
    437
    53
    May 20, 2008
    London
    How many payloads do you have in the luma/payloads folder. I believe if there is only 1 it will just autonomy that. 2+ and the menu should appear.
     
  4. Random3dsGamer
    OP

    Random3dsGamer Newbie

    Newcomer
    2
    0
    Jun 5, 2017
    Gambia, The
    Ok that did the trick, thank you very much.
    I posted a screenshot with all the important folders, but thanks to @xelrix the problem was solved! But Thank you too!