OK... I changed the timings slightly. Forgot to put in OP.
Anyway, you know how you changed from dual boot to autoRCM or visa-versa?
Well... Keep holding. Other rapid blinks follow. Let go on the one you want.
1) Hold down VOL+. Nothing willappear to be happening chip-side... Keep holding...
2) LED will light... Keep holding...
3) LED will rapid blink (this is dualboot / autoRCM switch)... Keep holding
4) After a few more seconds another blink(this is for payload1.bin, payload2.bin selection)...Keep holding
5. Next, you will see yet ANOTHER blink, just like in step 4... only this time, we need to let go DURING the blink.
OK...You have let go...
You will see small blinks counted out...
1
then 2 blinks
then 3 blinks etc...
Blink 1 is Black, non-animated
Blink 2 is Black animated
Blink 3 is Red non-animated
Blink 4 is Red animated.
Hit VOL+ on your chosen "blink".
Done.
thx a lot. Now i have a red anmiated logo.
Sadly i noticed some small issues with this.
Enter prebootloader (interrupting boot):
in previous versions when you held power button down, there was a message to release.
I can hold it as long as i want, and after release -> i was in pre bootloader.
with v4 (i think), that changed -> now you have to release the power button precisely on the "release" message.
Issue 1 With (red) animated logo:
When the red animated logo is active (didnt tried with black animated), its really hard to get into pre bootloader.
When i hold PWR the logo is shown, the countdown begins and on 2-1 the switch powers it off!
Thats not the case with the NOT animated logo, so it seems there is a wrong timeout (maybe the animation time is missing)?
Issue 2 With red logo:
On the info screen, the background of the text is red, which is really ugly and hard to read.
I am back at the oem black logo for now.
Keep up the good work
pOpY