- Thread starter NielsVisser511
- Start date
- Views 1,522
- Replies 9
send me a PM, I know a company but they can't advertise it for obvious reasons. I used a company in NL and they shipped the switch back to Belgium
Any repair shop that does laptop or cellphone should be able to complete the job. I suggest you disassemble it and bring the bare board to a shop and ask. Its a 5 min job include continuity check...
Sent from my SM-N975U1 using Tapatalk
As I said, if you remove everything and bring just the PCB to a shop, the soldering part shouldn't take more than 5 min. It a very basic smd job that doesn't involve hot air gun or bga station. Personally, I did mine in less than 3 min. People who are having issue are usually because they don't have the proper equipment, not it require any advance skill.
Similar threads
- No one is chatting at the moment.
-
@
Psionic Roshambo:
I wonder if I could recommend that to some emulation devs that perhaps the sound could use some smoothing out to simulate those old TVs -
@
Psionic Roshambo:
I think a few of the early systems could benefit from that, at least up to the 8 bit generation, by the 16 bit generation I think TVs had gotten a lot better in almost every way
-
-
-
-
-
-
-
-
-
-
@
Xdqwerty:
it says it only works for the original R4, R4i Gold (r4ids.cn), R4iDSN (r4idsn.com) and Acekard R.P.G. -
-
-
-
-
-
@
Psionic Roshambo:
Just give it a try, but honestly if you have a 3DS you can play DS games without a card just off the internal SD card
-
-
-
-
-
-
-
