I think its 3 long flash, timeout glitch.Hi, thank you for responding.
So those are 3 short flashes?
Yes I checked and it was about 780. same as most of the other connections. Only point I was really not confident in was my CPU point and from my understanding it cannot be checked with diode mode.
edit: After comparing to another video of someone else's error codes, I think they are 3 long flashes which is just the generic "could not glitch" error. Is this always a dat0 issue? Doesn't dat0 have more unique error codes on the list as well such as:
*** No eMMC CMD1 responce (bad eMMC?)
**= No eMMC block 1 read (should not happen)
*=* No eMMC block 0 read (eMMC init failure?)
*== No eMMC CMD1 request (poor wiring, or dead CPU)
=** eMMC init failure during glitch process
I would like to test if I corrupted/killed my emmc. Best way to do that is just to desolder everything and try OFW?
=== Glitch attempt limit reached, cannot glitch
The 3 short flash, cmd1 response not detected, its occured before the glitch (before blue light).
And yes its the dat0 adapter. I experience that timeout glitch too. Measured the diode mode value around 580 then shift it a little bit then measured again its around 600 then, its works.