Hello!
First and possibly last post from me.
[Yes] Newest Homebrew Channel installed
[Yes] This file pack (v1.1+IOS rev 9)
[Yes] The original IOS36-64-v1042.wad file
[Yes] Extract the usbloader.rar file into the root of your SD card.
[Yes] Stick the IOS36-64-v1042.wad file into the root of the SD card.
[Yes] Boot the Homebrew Channel, run the IOS installer
[Yes] Select "WAD Install", it should install automatically
[Yes] Reset Wii
[Yes] Insert a USB drive into the Wii
[Yes] Boot the homebrew channel, select USB-LOADER
So, everything above works fine.
However, nothing occurs after I load the USB-Loader (1.1)
I also used the newly released 1.2 version without success.
With Version 1.2, I can select my removable storage device (which it appears to detect) and it attempts to mount, but even after 30 seconds (and multiple minutes), there are is no response.
To try to get the USB Loader up and running, I have tried the following
I used the CIOS Remover (from Waninkoko) and applied the CIOS package
I used both USB ports on the WII
I used the 'WBFS' initialization utility
I am running an American Wii with System Update 4.0
Stuff that shouldn't matter, but might
I am just using the Wii Remote
There is a DVD-RW inserted (yet I tried this process without any discs inserted)
The storage device I am using is a 250GB internal hard drive formatted as NTFS and then 'WBFS ? init' to the Wii Backup File System connected by an SATA -> USB Cable (It looks something like this -
http://www.newegg.com/Product/Product.aspx...N82E16812232002 )
Is there some additional information I should provide?