So, after getting my NNID screwed up when updating RxTools so that I could run 10.5 EmuNAND, I was following some directions to get it fixed. One of the steps was to use TinyFormat to format my EmuNAND after backing it up. I used ThemeHax to get to the Homebrew Launcher, and ran TinyFormat from a 3dsx file... ...and apparently formatted SysNAND by mistake. I'm completely clueless on what to do now. Just what exactly did I lose? I'm on 9.0 SysNAND firmware, so worst-case scenario is that I just have to set everything up from scratch again. Is my EmuNAND still there, and the different CIAs that I had installed on it? Also, ThemeHax apparently is gone now. I'm going to need to re-install it, except I have a minor problem there as well. I never really paid attention to what entry-points were out, since I had a Sky3DS with Cubic Ninja on it. I lost that ages ago. I never needed it once I had ThemeHax running. Thing is, I need some entry point to get to the Homebrew Launcher to re-install ThemeHax. Any suggestions? My final goal is to get RxTools running again. I've been hearing that A9LHax is a thing now, is it worth looking into as a new way to get my EmuNAND going again? Keep in mind, this isn't so much a "How do I get started again?" thread as much as "I'm kind of forced into a fresh start. What's the best way to go about it now compared to back before Pasta was a thing?"