Homebrew There is an ERROR when booting to Emunand Luma3ds

[Xerkies]

Can someone please figure this out why this is happening?
When I go to Emunand I press the L button and the Start button to go there but there's a error that shows
"An Error has occurred:
An old unsupported EmuNAND has been detected. Luma3DS is unable to boot it." What's going on? Does something have to be updated? Because I've been searching why and there was nothing there to figure out.

 

[GlowskiBroski]

On the Github, It shows you a tutorial on how to boot emunand on firmwares 4.X and below. It seems you have one of those firmwares. So, go to this link: https://github.com/AuroraWright/Luma3DS/wiki/Installation-and-upgrade and find the "To boot 3.x-4.x NANDs" section. Hope this helps.

 

[Xerkies]

On the Github, It shows you a tutorial on how to boot emunand on firmwares 4.X and below. It seems you have one of those firmwares. So, go to this link: https://github.com/AuroraWright/Luma3DS/wiki/Installation-and-upgrade and find the "To boot 3.x-4.x NANDs" section. Hope this helps.

I'll try that thanks

 

[Xerkies]

On the Github, It shows you a tutorial on how to boot emunand on firmwares 4.X and below. It seems you have one of those firmwares. So, go to this link: https://github.com/AuroraWright/Luma3DS/wiki/Installation-and-upgrade and find the "To boot 3.x-4.x NANDs" section. Hope this helps.

My Emunand is 11.0
The files didn't work and is there a way I can check the emunand version?

 

[GlowskiBroski]

Strange..... Attempt to reinstall Luma3ds. Make sure the emunand is 11.2 also. If you reinstall it, it should fix it as long as your emunand is 11.2