Hacking SX Pro booting without Jiggle

[dumbledore42]

I tried every method also with tin foil but nothing works. I have 6.2 and the latest boot.dat from sx page

 

[CaptainAdama]

I tried every method also with tin foil but nothing works. I have 6.2 and the latest boot.dat from sx page

I would not try with paperclip or cable before shortening the wrong pins. Order a new jig using Ebay Kleinanzeigen: https://www.ebay-kleinanzeigen.de/s-switch-jig/k0

Ich würde es nicht weiter mit einer Büroklammer oder etwa Alufolie probieren. Worst case ist Du verbindest die falschen Pins. Schau mal unter https://www.ebay-kleinanzeigen.de/s-switch-jig/k0 oder Ebay selbst, die Jigs kosten nur ein paar Euro.

Jürgen

 

[dumbledore42]

I DID IIIIIITTTTTT
I had to press the power button more then one nanosecond .
I pressed it two seconds till the screen enlightend then it worked.

Now I have to install Autocrm?

Thanks everyone. Greetings from Germany.

 

[S3phi40T]

I DID IIIIIITTTTTT
I had to press the power button more then one nanosecond .
I pressed it two seconds till the screen enlightend then it worked.

Now I have to install Autocrm?

Thanks everyone. Greetings from Germany.

In that manual I mentioned you have written I German exactly how to do it.
It's in SX bootloader"s options.

Wysłane z mojego Redmi Note 4 przy użyciu Tapatalka

 

[yusuo]

Hello,
i have installed SX Pro and everything works fine.
I did an upgrade to the newest 6.2 with the newest SX Pro files.
Now I have to use this thing called Jiggle (?) which you put on the right side of the switch.
But I cannot find it anymore. The Dongle i have is always reachable. But because I never use the jiggle I cannot find it anymore.
Any ideas how I can boot with just using the dongle?

Where are you in the world, I have a spare jig I'll be happy to send you if you are happy to cover the postage

 

[oldmumak]

The best thing to do is solder a 7k-10k ohm resistor on the joy-con. Never mess with a jig again.