Too vague informationI did a factory reset on my switch and when it booted off for the reset it stayed off and now wont turn on again.
Can i fix this?
Tried this but no succesPlug your Switch to charger directly (without dock) and press power button during 15 secs
Was on 6.1 fw.Too vague information
What fw? What did you change before reset? Hacked switch? Possible autorcm?
I dont really know much about SX OSTried this but no succes
--------------------- MERGED ---------------------------
Was on 6.1 fw.
Had osxs installed but autorcm was disabled.
I dont really know much about SX OS
but really it sounds like one of these 2 :
- Console went into RCM mode somehow (try to connect to PC or Push a payload with phone)
- Black Screen Freeze (try to remove memory card and then hold power button for 30 seconds. Make sure your console is charged)
Ok wil try this in a few hours.Backup your data on the SD card then do a full format with guiformat
Since you're on 6.2 at times it can mess up on a black screen especially if you're downgrading and as a result would require the nocmac patches to run
. if that doesn't work then your option would be to rebuild your NAND with ChoiDujourPC.
You're lucky to be on 6.2, it makes the process simpler.
Backup your data on the SD card then do a full format with guiformat
Since you're on 6.2 at times it can mess up on a black screen especially if you're downgrading and as a result would require the nocmac patches to run
. if that doesn't work then your option would be to rebuild your NAND with ChoiDujourPC.
You're lucky to be on 6.2, it makes the process simpler.
normal factory resetJust a factory reset or did you restore NAND?
no it was off.You can try the 30 Seconds power trick, was it in AutoRCM when you reset?
no it was all still on there.If you factory reset it most likely it also cleaned the contents of your sd card.
its been charging for 2 days now.maybe it is in RCM and ran out of battery
try to keep it plugged in for about 2 hrs atleast