He had it before.What made you recommend exFAT?
He had it before.What made you recommend exFAT?
I made a backup of my backup and then messed with it. So in theory the orignal backup should work?
I just tested the original backup i made with sxos with sxos and it gives me Errcode=00FFFD47.
So my only backup is not working. I guess my switch is useless then?
He had it before.
I know that FAT32 is better but i tried it non the less.Did you figure it out? The Error code you reported means that SXOS didn't locate a backup to restore. The directory structure I indicated should help with that.
Cautious approach to introduce less variables that could introduce other potential free radicals in an effort to trouble-shoot. I appreciate it. Some people would take it as advice that they should use exFat, lol.
So I restored my NAND with sx os and it still boots into blackscreen. I think i can now stop trying to fix my switch lol.
That's too bad. Strange that you can see at atmosphere screen but nothing else. I think you have autoRCM enabled or you made the backup when the boot 0/1 were dirty.
Tell me something, yo... You tried to downgrade?Yeah AutoRCM is definetly not enabled i made sure about 100 times.
Yeah that seems quite plausible. Too bad.
Tell me something, yo... You tried to downgrade?
What about if you wait a few in that black screen, press power to wake the system and press volume up or volume down? Or plug the charger? Any icon on screen?
If the original Nand is the culprit, it's because:Yeah already tried everything you just said. And everything that has something to do with the original firmware does not work, so also no indicator that the switch charges. I only see charging in Hekate.
There's something you are not telling. The Switch doesn't simply refuse to boot. That's almost impossible.Well i also tried that and i still have the same blackscreen.
Maybe i really toasted anything inside the switch although i dont know how.
Yeah i tried a lot of things before i made the original post. Because i didnt know what to do i made the post.
And really. Disabling AutoRCM and booting without sdcard really just ends in a blackscreen.
If there is anything im not telling you it is because i dont know.
Can you boot into maintenance/recovery mode?
In order to enter Recovery Mode, the following combination must be performed:
- With the system powered off, press and hold Volume Down + Volume Up;
- Press the Power button while still holding Volume Down + Volume Up;
- Let go of the Power button and keep holding Volume Down + Volume Up until the maintenance applet shows up.
Already tried that but jsut to make sure i just tried it again and it really just does nothing.
Just a blackscreen.
Should i try to load android on my switch? Maybe i can test some things there, like ram etc.
As I was saying boot0/boot1. I got the same black screen on emmunand because of a dirty boot0/boot1.