Hello everyone.
I have a switch that after putting picofly on it presents a couple of problems.
One is that I don't get into the original firmware, I get an error of "unknown pkg1 version hos version not supported" and on the other hand, when I boot from emu emmc, everything works fine but when the console goes to sleep, it stays blocked and I have to force the reset by pressing the power button for 10 seconds.
Say that this console had been modified by software before and that the card is the same. A 1tb sandisk.
On the other hand, when hekate starts I get a warning that the emmc is initialized in slow mode.
Let's see if someone can tell me where I could have the problem.
Greetings and thank you.
I have a switch that after putting picofly on it presents a couple of problems.
One is that I don't get into the original firmware, I get an error of "unknown pkg1 version hos version not supported" and on the other hand, when I boot from emu emmc, everything works fine but when the console goes to sleep, it stays blocked and I have to force the reset by pressing the power button for 10 seconds.
Say that this console had been modified by software before and that the card is the same. A 1tb sandisk.
On the other hand, when hekate starts I get a warning that the emmc is initialized in slow mode.
Let's see if someone can tell me where I could have the problem.
Greetings and thank you.