switch with picofly black screen after sleep mode

[vivancolorca]

Hello everyone.
I have a switch that after putting picofly on it presents a couple of problems.
One is that I don't get into the original firmware, I get an error of "unknown pkg1 version hos version not supported" and on the other hand, when I boot from emu emmc, everything works fine but when the console goes to sleep, it stays blocked and I have to force the reset by pressing the power button for 10 seconds.

Say that this console had been modified by software before and that the card is the same. A 1tb sandisk.

On the other hand, when hekate starts I get a warning that the emmc is initialized in slow mode.

Let's see if someone can tell me where I could have the problem.

Greetings and thank you.

 

[jmmc]

Add one more resistor to dat0 and cmd points to fix slow emmc. You can try if fixing slow emmc fixes the sleep mode too.

 

[vivancolorca]

Add one more resistor to dat0 and cmd points to fix slow emmc. You can try if fixing slow emmc fixes the sleep mode too.

Ok, thanks for te answer, i go to try this. Thanks.

 

[jmmc]

Ok, thanks for te answer, i go to try this. Thanks.

Let me know the result

 

[vivancolorca]

Let me know the result

all the problems have been solved thanks to your help.

Thanks you very much

 

[tony39]

Hi I installed pikofly on a switch v2 but after a while you turn it off and on again it doesn't start anymore the black screen remains as if it were dead do you have a solution thanks

 

[Hayato213]

Hi I installed pikofly on a switch v2 but after a while you turn it off and on again it doesn't start anymore the black screen remains as if it were dead do you have a solution thanks

Try what it says in post #2.

 

[tony39]

Prova quello che dice nel post #2.

grazie mi puoi mandare dove non trovo il post 2 mandami un link grazie

Post automatically merged: Aug 18, 2023

grazie mi puoi mandare dove non trovo il post 2 mandami un link grazie

Post automatically merged: Aug 18, 2023

I have already put 2 resistances to the dat0 and 2 to the cmd

 

[tony39]

Aggiungi un altro resistore ai punti dat0 e cmd per correggere l'emmc lento. Puoi provare se la correzione di emmc lento risolve anche la modalità di sospensione.

Salve io ho il problema che ci mette tempo ad accendersi e molte volte quando la spengo non si riaccende più
Hi I have the problem that takes time to light up and many times when I turn it off it no longer rekindles