Hello guys,
Got a quick question as i just modded my oled switch with instinct v6 black everything was fine untill the morning i found it frozen and randomly shut down, so formatted the card and tried again all went well even nand dumped fully.
A few mins later decided to restart the device and the instinct turns to white, redid the whole solderjob again and still the same issue.
Below are the readings as far as i recall.
A 0.5
B 1.5
C 0.5-0.6
D 0.5
I attached the photos as well i dont know where to look.
Appretiate an extra eye maybe im missing something that is my first instinct used to do hwfly with wires.
Update on the readings
A 0.475
B 1.5
C 0.65
D 0.65
Regarding 3.3V im not getting any readings but chip is powering on as the video i shared.
Shall i jump the wire to the chip directly
Got a quick question as i just modded my oled switch with instinct v6 black everything was fine untill the morning i found it frozen and randomly shut down, so formatted the card and tried again all went well even nand dumped fully.
A few mins later decided to restart the device and the instinct turns to white, redid the whole solderjob again and still the same issue.
Below are the readings as far as i recall.
A 0.5
B 1.5
C 0.5-0.6
D 0.5
I attached the photos as well i dont know where to look.
Appretiate an extra eye maybe im missing something that is my first instinct used to do hwfly with wires.
Post automatically merged:
Update on the readings
A 0.475
B 1.5
C 0.65
D 0.65
Regarding 3.3V im not getting any readings but chip is powering on as the video i shared.
Shall i jump the wire to the chip directly
Attachments
Last edited by Xandroz,