Switch Lite bricked. AutoRCM enabled?!

[R0nny01]

Hello all. I recently bought a bricked switch lite to see if i can fix it. The pre-owner of the switch said that the autorcm bit was set. picofly was removed by pre-owner and i installed picofly back into it to see if i can boot hekate. Picofly tries to glitch (Blue LED), after that i get this error code: short, long, long (*==). Is there a way to get the switch working again? I thougt i could remove the emmc and solder a new emmc back. If this works i will try to dump keys from it to decrypt the original emmc if possible so i can remove autorcm. Could my idea work? Any other ideas?

 

[jkyoho]

picture of motherboard soldering spots condition.I don't think patched console could turn on autoRCM unless some pad/trace broken on thd board.

 

[R0nny01]

Here are the pictures u asked for. Im sure that autorcm is enabled because the switch is in APX Mode if i connect it to my pc.

 

[jkyoho]

clk right pad looks tricky to me, also the resistor seems not sitting on there well.
Can you remove all cable and check the pads?

 

[R0nny01]

Pads looks fine to me. Resistor is also okay and have contact to pads. Exept the cpu flex all cables are removed. Pads looks fine to me. Need a new battery for my multimeter -.- just died. Switch still in APX Mode.

EDIT: I replaced the emmc, still same error. APX Mode still there. Found some explanation about my error: *== No eMMC CMD1 request (poor wiring, or dead CPU)
My wiring is okay, so i guess there might be a problem with the cpu..