Hacking Switch is dead and won’t charge in auto rcm

[mickthestud]

I’m sorry I’ve searched and I know this has been asked many times before but keep getting so many different answers . Some say you need to boot with Hekate to start charging I have always used sx pro and had nothing to do with that stuff

 

[M7L7NK7]

Charge your switch for around 20 minutes and it will have enough charge to boot

 

[Kubas_inko]

Switch charges in RCM, just really slowly. So leave it there for an hour and then boot to horizon (via your prefered way).

 

[mickthestud]

Switch charges in RCM, just really slowly. So leave it there for an hour and then boot to horizon (via your prefered way).

Can’t I boot it with the sx pro dongle like I usually do

 

[Kubas_inko]

Can’t I boot it with the sx pro dongle like I usually do

And is it charged??? Both the dongle and switch.

 

[M7L7NK7]

Can’t I boot it with the sx pro dongle like I usually do

Charge your switch for around 20 minutes and it will have enough charge to boot

 

[DiscostewSM]

As far as I understand with li-ion batteries, the points where it takes the longest to charge a portion of the capacity is when the battery is near full, and when it is near drained. When drained, the system won't turn on at all, even if plugged in for charging. It has to reach is certain percentage before it will even allow the system to turn on.

Patience is a virtue.

 

[Zonark]

Charge your dongle as well

 

[raheer]

I’m sorry I’ve searched and I know this has been asked many times before but keep getting so many different answers . Some say you need to boot with Hekate to start charging I have always used sx pro and had nothing to do with that stuff

i had the same problem, solution: Hold 15-30seconds the power off button and put the charger in and let it charge^^