Hacking Question Switch dont boot after AutoRCM enabled

[DevilsAdvocBR]

With holding Volume up and then inject the payload, i was able to remove auto rcm. Now the Switch need the Jig.
But i am still not able to Inject via Mobile. My S8 dont still recognize the Switch. I tryed a lot of cables, but no one works.
I tryed a usb memory stick and my pc-mouse, but none of them gets recognizet from my S8.
Maybe the S8 ist a peace of S****?
I think, that i stay on Auto RCM off and use a jig and the PC, because nothing else works.

Thank you.

Well, maybe its's a problem with your OTG adapter. A pen drive connected to the smartphone via OTG adapter should work, if there are no problems related to the drive or the adapter itself.

 

[Burillos]

To be honest I haven't ever been able to get my note8 to work either. With or without those cables. My Galaxy S5 works just fine though. I guess I'm not much help here.

lol i am glad not to be the one with this problem. But i will not give up, i ll try a spezial OTG Cable and tell you if it works.

 

[Arithmatics]

try this its copy pasta from another thread I posted in but if you don't have the SX pro just plug in your USBC cable instead

Its kinda janky but plug in a micro usb cable while connected to a PC into the SX PRO
Plug the SX PRO into the switch and listen for a connected noise
hold Power + Volume up and listen for a disconnect sound
open up TegraRcmGUI and select hekate_ctcaer_3.2 as a payload
Hold power + volume up and listen for the connected noise
as soon as you hear it start spamming the inject payload button as it will show the switch in RCM mode for 2 seconds at most
if you get it to send the payload the switch should boot into hekate
if it does immediately plug in a normal charger

Apparently his switch doesn't have this problem.