Hacking Red light when trying to RGH

[Anthony Michael]

Hey guys, I am trying to RGH my console and when I try to boot it, so I can get into XELL, it shows a red light, here are some pics.

 

[DinohScene]

Red light on the RF board?

 

[Anthony Michael]

I get the red light on the power button and a red light on the x360ace

 

[lexluth0r]

You have a bridged connection somewhere... did you use flux?

 

[Anthony Michael]

Yeah, I did
I cleaned the flux around it, once I was done
I just checked and it doesn't look like I have a bridged connection.

 

[lexluth0r]

Well... have you tried reflashing the original nand dump and disabling the chip to see if the console loads stock?

 

[Anthony Michael]

I haven't, I'll try
I can't disable the x360ace v3 without removing the wires
can I just remove the power and try like that?
Update: I removed the wire from point D on this picture, and it worked. I have to resolder it and see if it works

--------------------- MERGED ---------------------------

This picture, point D is giving me the problem
Would I be able to solder that point to another area on the MOBO?

 

[lexluth0r]

Maybe I'm not sure on that but yea I would try that first then if it boots normal you know it's not a soldering issue

 

[Anthony Michael]

lost spot for point D, can't find the spot where I'm suppose to solder, can't I solder that wire to another point on the XBox?

 

[DinohScene]

Scrape a bit off the trace right before point D and solder it on there.

If the console still boots to stock, you haven't destroyed it and it doesn't need trace repair then.