Taken from here:
http://gbatemp.net/t218725-sneek-di-quick-guide
Puneek by giantpune (Thanks for sharing)
giantpune decided to share his source with us. You want it ??? You know you do !!!
email: [email protected]
This is from the source, this is not mine, this is giantpune all the way.
Take a look:
Quick and dirty to verify that the pune modules are working (USB)
- Must have boot2_USB.bin on SD root (as boot2.bin).
- Must have boot2_USB.bin on USB root (as boot2.bin).
- Must have di.bin on USB root.
- Do not need di.bin on SD.
- Do not need bootmii folder on USB.
- Must have working NAND dump on USB.
- Do not need NAND on SD.
- Must have correctly installed game on USB
(Thanks
fogbank)
---------------------------------------------------------------------------------------------
2 new icons to distinguish Pune's mods (Thanks
pepxl)
Would this allow me to boot sneek from my SD nand and then launch my backup library w/ a usb launcher? how about boot my nand from usb and then launch a backup from usb with launcher? Why hasn't this been released officially or more documented? has it been released officially? Would i need to change how my backups are already formated, any need for discEX? Lamens terms? Are there any guides that would help me along to setting up a build enviro in ubuntu, and following along to build all this stuff? what stuff would I need?
Thanks.
also...can someone advise me here...too. I made it through 25 pages of the SNEEK-DI Guide...but I can't find the answer.
Can someone help me? I am currently running SNEEK (NON DI) and it booted up fine and I know its working cause I have 1000+ free blocks. However, I can't get the homebrew channel to run. I get the scam warning when I run it, and it just hangs there.
I followed the instructions to install HBC which I found as Homebrew Channel.wad on my Wii, to the Sneek I made. However, it doesn't change anything, I still get the scam message and nothing happens.
I made the sneek from a bootmii backup of 3.4u. When I attmpted to install HBC to sneek, I copied the hbc.wad into my sneek nand on the SD, and then copied over the tickets from my original nand, just like it said. Still not working. However!!! my HBC IS! 1.08, not 1.07. Does that matter?
I wanted to get HBC up and working so I could install the latest Waninkoko cIOSX20, cause I hear it has sneek support........thus allowing me to run my usb loader off my USB drive and launch my backups. Can I do that?
(I still don't know what PUNE's custom stuff is all about......)
NReale3370 said:
You can, but if its 1.0.8 don't bother it doesn't work in SNEEK
lol...okay. So then can I? run USB loader via SKEEN if I already have HBC .08?
ChokeD said:
sakax said:
QUOTE(conanac @ Aug 28 2010, 10:45 PM)
Go to the first page of this thread, and there is a section called "Other Valuable Downloads" which has a link to font.bin.
Let me know if you still find any problem to get it.
thanks, i got sneek running :-)
however hbc 1.0.8 is inluded in my virtual nand. how do i remove hbc 1.0.8 and replace it with hbc 1.0.7. i cannot install it as my hbc doesnt work in nand right now.
can i use bannerbomb in my virtual nand?
Showmiiwads from the first post, on how to install HBC to your NAND will delete it out of the NAND and install the 1.0.7 HBC.WAD.
Right click and delete.