Hacking Hardware Nintendo OLED won’t turn on and there are no lights; Instinct v6 chip installed

[Jagovi]

Hi!!

I've done many chip installations and none have failed me. This time, after installing the chip, I connected the battery and plugged it into the Type-C port to turn it on. The chip went through its initial startup routine and everything seemed fine. I proceeded to mount the motherboard back into the console, but after connecting everything, it won't turn on. I've removed the dat0 point, tried another flex, attempted to power on without anything connected, but it still won't turn on. There's no light on the chip and the console doesn't show the OFW startup. Can anyone help me? The diode mode values are listed here:

Black ground
SP1 .20 .00
Sp2 .20 .00
A .698
RST 2.943
C .705
D .616
3.3v .803



Red ground
A .486
RST .408
C .442
D .460
3.3v .452

I'm uploading some pictures.

Thanks!!!

 

[Blavla]

Hi!!

I've done many chip installations and none have failed me. This time, after installing the chip, I connected the battery and plugged it into the Type-C port to turn it on. The chip went through its initial startup routine and everything seemed fine. I proceeded to mount the motherboard back into the console, but after connecting everything, it won't turn on. I've removed the dat0 point, tried another flex, attempted to power on without anything connected, but it still won't turn on. There's no light on the chip and the console doesn't show the OFW startup. Can anyone help me? The diode mode values are listed here:

Black ground
SP1 .20 .00
Sp2 .20 .00
A .698
RST 2.943
C .705
D .616
3.3v .803



Red ground
A .486
RST .408
C .442
D .460
3.3v .452

I'm uploading some pictures.

Thanks!!!

If you lifted this up or severe the connection it will not boot anymore.

 

[Jagovi]

I think that the point D it’s fine.
I have scratched a bit and tested with multimeter and I have continuity and I am getting a value which look correct. How can I test it?

 

[Hassal]

I think that the point D it’s fine.
I have scratched a bit and tested with multimeter and I have continuity and I am getting a value which look correct. How can I test it?

Are you sure you haven't grounded the point?

 

[Jagovi]

Are you sure you haven't grounded the point?

I have tested continuity but I have not continuity with ground in any point

 

[Hassal]

You said your chip isn't powering on, have you checked your battery?

 

[Jagovi]

You said your chip isn't powering on, have you checked your battery?

What should I check from the battery? Between black and red wires it has 4.09v. Something else?

Post automatically merged: Sep 11, 2023

The problema was with the flex cable. I have installed it using aw36 and all right!

 

[YSlamX2]

I just installed v6 on my oled. All diode values are correct but the switch won’t power on. No lights on the mod chip either. Redid the 3.3v just in case and consistently get correct values but still no power. Please help.