Hardware Looking for an alt cap for 3.3 V on switch lite botched sxlite install

[Xandroz]

Hey guys so basically the cap where i solder the final chip to, one of the sides got damaged and its not giving power to the chip
I am sure the cap is broken
I put a picture of the cap from another install

i have a doner normal switch board
Any idea which one to use

 

[Modificatorul]

I recomended 10uf 0402,10 v, not removed and tested is filtering the 3.3 line.
on switch normal next to mn92 is a 4.7 uf cap 0402 use that.
https://gbatemp.net/threads/compone...stly-the-motherboard-and-main-console.525026/

Please report if is stable enough, i don't now if i will remove one and test

 

[nero99]

Hey guys so basically the cap where i solder the final chip to, one of the sides got damaged and its not giving power to the chip
I am sure the cap is broken
I put a picture of the cap from another install

i have a doner normal switch board
Any idea which one to use

Always remember, you could have a dud sx lite. I have two, the first one just refused to work no matter what, the new one works just fine. And yes, I am very decent at micro soldering. You could have also got solder on a trace that connects to the cap as well

 

[Xandroz]

I am sure its dead because i saw it being f*** with my
Own eyes under the microscope

will try the recommend cap from the normal switch hope it works

--------------------- MERGED ---------------------------

Always remember, you could have a dud sx lite. I have two, the first one just refused to work no matter what, the new one works just fine. And yes, I am very decent at micro soldering. You could have also got solder on a trace that connects to the cap as well

And this was working fine and got the licence but some short was messing the switch, so when i desoldered and soldered it broke on me