guys i just got my SX pro
im following SXOS-manual_v1.pdf from TX website.
I have versin 1.3 on the SD card ( sandisk 200GB SDXC card) formatted both in switch & PC
Switch is version 5.1FW (needed to update for SDXC support)
Now i go into RCM mode TegraRcmGUI goes green and i can launch the payload, the switch then boots and i have selected AutoRCM which installed, when i tap boot to custom FW the switch reboots back to the orginal FW.
Some guides say have the dongle connected some say dont - confused.
Something im doing wrong?
im following SXOS-manual_v1.pdf from TX website.
I have versin 1.3 on the SD card ( sandisk 200GB SDXC card) formatted both in switch & PC
Switch is version 5.1FW (needed to update for SDXC support)
Now i go into RCM mode TegraRcmGUI goes green and i can launch the payload, the switch then boots and i have selected AutoRCM which installed, when i tap boot to custom FW the switch reboots back to the orginal FW.
Some guides say have the dongle connected some say dont - confused.
Something im doing wrong?