Hacking Hardware Instinct-NX V6 booting issues

[Teo338]

Hi guys
I soldered my Instinct V6 today in my switch OLED. Sadly, when booting, it gets the following LED-Pattern:
Training LED (just blinking Yellow) - Blinking Purple for a long time - Flashing Blue LED multiple Times (more than 3 times!!!) - Boots into OFW
I couldn't find any problem description for this pattern.... I also checked over USB the diagnostics and it said at the end, when the Blue LED flashes "RST Failure"

This are the Point values I measured in diode mode:
A - 0.585
B - >= 1 (my multimeter is a cheap one from china and can't display more than 1)
C - 0.745
D - 0.507
3.3 - 0.862
SP1 - 0.013
SP2 - 0.013

As far as I know, those values are correct (if I'm not wrong).

I can't see any problem... Maybe I'm stupid, but do you have any solutions?

Right now, i get also the problem that at the end, the LED flashes RED and the diagnostics says "Exhausted all options" (See attachment)
Maybe there is a connection between those two errors...

Post automatically merged: Saturday at 9:38 PM

Here is another attachment which wasn't uploaded (i dunno why)

 

[thesjaakspoiler]

These error codes match your color codes :
https://gbatemp.net/threads/instinct-nx-purple-flash-then-boots-into-ofw.639599/
So that would mean SP1/SP2 disconnected.
Is the flat cable inserted correctly / far enough?
Also maybe check for continuity on the flat cable to see whether there is no crack in it.
There are some pictures floating around here that show the layout of the flat cable.

 

[Teo338]

These error codes match your color codes :

It isn't a LED pattern on that list. At the end, it doesn't blink blue three times, it blinks more than three times. I also checked it: when i disconnect the flex cable, I get the three blinking blue pattern. Also, the error message wouldn't be "RST Failure" when it blinks three times (something with "Flex cable" would come up)

Post automatically merged: Yesterday at 9:24 PM

I got now a video of the problem with the blue light