I wait a week for my SP to arrive and it has a bad battery, another for the replacement battery finally after I stick in my EZ Flash reform into my SP and pull it out, it feels like its stuck. Apparently this was a common issue with the reform and SP's. I pull it out and notice the plastic is a bit wiggly, especially where the screw is. I don't think its a big deal so I tighten everything up. I reinsert it into my sp and wont boot. I test it on my Micro (which goes into MUCH more easily) and I get a white screen. I disassemble, clean everything , tighten the screw and still a white screen. The circuit board looks absolutely fine. The plastic might be a tiny bit warped but once its screwed it looks nice and tight, like everything is fine. I have no idea what the issue is. I sincerely doubt it software related (reformat the sdcard) etc because the issue began after I pulled it out and it was wiggly. I read other posts and many people complained about the EZFR issue with being too tight but I couldn't quite find one with my issue. I guess I'm asking A. for advice on how to fix this and B. What are some alternative carts I could purchase, this thing cost me 50 and lasted me about 4 months so I guess I just have to take the loss, I don't know much about what the "top carts" are, I don't want an Everdrive tho because its expensive and sticks WAY out of the console.
