Hello guys, this is my first post here! I just got a MIG Switch card out of curiosity and I was tinkering with it. For those who don't know, it's used by placing XCI dumps as well as other game specific bin files in the sd card of the MIG Switch, and are obtained from the original cartridge by using an app like nxdumptool. Two of these bin files are mandatory to get the game to boot: Initial Data.bin and Certificate.bin. They stay the same for every cartridge of a specific game. Now, if you want to use an XCI dump from a shady website it's impossible to get it to work without those files. By using the Certificate.bin from another game it has no problem, but this does not count for the Initial Data.bin. So I looked for a way to obtain this Initial Data from an XCI file and read a bit of the XCI file documentation from switchbrew dot org. Here's what I understood so far: The Switch checks if the cartridge is valid by doing a challenge–response authentication on the Initial Data. The Package ID is contained both on the XCI and the Initial Data, on positions 0x110 and 0x0 respectively. The Initial Data hash is on the XCI at position 0x160. It is calculated by doing a SHA-256 hash on the full Initial Data content. So I was wondering, is there a way to to construct a functional Initial Data file starting from an XCI dump? I also tried a reverse approach by editing the Package ID in the Initial Data from another game, generating the Initial Data hash and putting it in the XCI file but is not enough to get the Switch believe it's a real game. Sorry if this may seem stupid but let me know what you think.

mig switch not working/updating??

stickybit · 2024-03-28T19:59:51+00:00

just got my mig switch and followed instructions to the T to update it and all im getting is a red light and then a message saying cart not recognised, all im trying to do is update it to the latest firmware, it says it should flash blue when...

Hacking Gaming Misc Dbz kakarot corrupted after using reboot to payload

Thread starter meh2
Start date Jun 4, 2023
Views 1,280
Replies 5

meh2

New Member

Newbie

Level 1

Jun 4, 2023

Even after updating atmosphere and installing the latest sigpatches dbz kakarot is corrupted every time I use reboot to payload

Fw: 16.0.3
Bootloader: hekate 6.04
Atmosphere version: 1.5.4

Antosabea

New Member

Newbie

Level 1

Sep 3, 2023

Same problem. Kakarot V1.32 works fine, but 1.40 is corrupted.

DAVYSGAMING

Member

Newcomer

Level 2

Sep 3, 2023

Antosabea said:
Same problem. Kakarot V1.32 works fine, but 1.40 is corrupted.

Works fine for me i made a cheat file for the new kakarot 1.40 60 fps + 60 fps cutscenes en some gfx codes its on the chanseygpt github page

Lamcza

Typ tego typu.

Member

Level 6

Sep 3, 2023

yep just tested it with reboot to payload on 1.40 works fine

impeeza

¡Kabito!

Member

Level 27

Sep 3, 2023

As always. Should be a lack if any sigpatches file(s) install them again using latest version and if you have a custom Atmosphère generate the corresponding patches using IPSCreator
And if you're unable to get latest sigpatches you also can use SYS-Patch as complementarity