Hacking Confused about a part of the A9LH guide

[AyanamiRei0]

First of all, I'm sorry of this is in the wrong place.

Ok I'm on part 3 of the guide I already have Luma3DS do I have to set it up again or do I leave it and I have already made a backup of both my Sysnand and Emunand just to be safe and I'm just going to make a backup of my SD card just to be safe.

 

[Skyshadow101]

Once you set up Luma, you should be good to go. Just go on to the next step.

Sent from my LGLS770 using Tapatalk

 

[AyanamiRei0]

Once you set up Luma, you should be good to go. Just go on to the next step.

Sent from my LGLS770 using Tapatalk

Ok thanks for the help.

Edit nevermind I'm still confused

 

[Skyshadow101]

Ok thanks for the help.

Edit nevermind I'm still confused

What are you still confused about? Tell me and I'll answer to the best of my ability.

 

[wiiando]

..............

 

[AyanamiRei0]

What are you still confused about? Tell me and I'll answer to the best of my ability.

It's pretty much just part 3 i already have Luma setup and updated to the newest firmware on Luma

 

[KunoichiZ]

It's pretty much just part 3 i already have Luma setup and updated to the newest firmware on Luma

Then start from part 4 of Plailect's guide if you want to install A9LH. That's literally all you have to do. You've practically completed Part 3 if your emuNAND is at the latest version.

Also, please make sure that you used TinyFormat on your sysNAND to unlink your NANDs. The instructions on how to do that are in Part 3.

 

[Kyojin]

I guess you should have started with the "Get Started" page. ¯\_(ツ)_/¯

9.0.0 - 9.2.0 (with an existing CFW): change menuhax to type 1, set your menuhax trigger to D-Pad down, then start the guide at Part 4. Note that anywhere "RedNAND" is mentioned, you can pretend it says "EmuNAND" instead as they are very similar and the instructions will be the same other than that.

 

[AyanamiRei0]

Then start from part 4 of Plailect's guide if you want to install A9LH. That's literally all you have to do. You've practically completed Part 3 if your emuNAND is at the latest version.

Also, please make sure that you used TinyFormat on your sysNAND to unlink your NANDs. The instructions on how to do that are in Part 3.

My nands have already been unlinked from each but I'm still going to use tinyformat anyway

--------------------- MERGED ---------------------------

I guess you should have started with the "Get Started" page. ¯\_(ツ)_/¯

I don't brain well it seems.