Broken dsi charging port

[SerialLain]

Hello fren, I got a Dsi with the charging port traces broken, can I just solder some wires from the legs of the charger port to thoses pads like in the pic below vv or am I misunderstanding them? If so, there is any workaround? Thanks!

 

[KleinesSinchen]

I've not even looked at this side of the board. On the other side you can get (+) on one point of EM1 and (-) almost everywhere. Measure continuity between the points on EM1 and those points you want to use in order to find out if the trace works.

My previous picture on this:
https://gbatemp.net/threads/burned-dsi-dc-pads-need-suggestions.592339/#post-9546176


Good luck!

 

[SerialLain]

:o I'm no good at electronics didn't know that I could use other (+) than (Vin). I'll try to do like in the other thread, Thank you!