Homebrew 3DS Menuhax problem Help

[Makku-Desu]

So basically , I downgraded my o3DS XL from 10.6 to 9.2 using the new memchunkhax3. Everything went fine and my 3ds is now 9.2.0-20E. On my other 3DS I got to install menuhax through browserhax without any problem, but in this one, it just won't let me install it. If I run menuhax manager (I tried both 2.2 and 2.0) through Ninjhax 1.1 it runs but the installation fails saying "failed to initialize am" and it asks me to use another entrypoint. So I tried with browserhax (which on this 3ds doesn't work very often) and when I try to open menuhax manager it gets stuck on the homebrew launcher and all I can do is turn it off. I tried several times , formatting the SD , downloading the files again , but it didn't help. Have you got any solution?

 

[Makku-Desu]

It is apparently not possible to do that as the new version is patched , the ironfall section on the eshop old version solution is erased

 

[Manuel9181]

Do you have change the theme on your home menu at least once? This is necessary in order to be able to install menuhax properly.

 

[MajinCubyan]

You're problem is you are usng a hella outdated version of Ninjhax. 1.1 doesn't have the same access to things as 2.5 and such. Wipe your CN, update your boot.3dsx and CN and you should be good to go.

 

[Makku-Desu]

I actually solved just a few minutes earlier then Majin's reply , but the problem is that I was using the starter kit from the old ninjhax website

 

[Makku-Desu]

Oh don't worry about that

 

[Patxinco]

@Feras2002 Ironhax cannot be used on firmware lower than 9.5, it's not a valid entrypoint for 9.2.

 

[WeedZ]

@Feras2002, 'when you try to act like a pro'.. lol

Can't use Ironfall on fw below 9.5 dipshit.