After cleaning:
Mid 300= 300°C and half air speed?
Not bad at all for first time. Just do not stress it out.
Have fun with a project.
What temp you used to take off MT?
I think 350 half speed, will work well.
Last edited by Agilato,
After cleaning:
Mid 300= 300°C and half air speed?
I removed the M92T36 with 420°C using a Yihua 8786D station, on 3/4 of its max. airspeedNot bad at all for first time. Just do not stress it out.
Have fun with a project.
What temp you used to take off MT?
I think 350 half speed, will work well.
How do I solder the capacitor? Using hot air or solder iron?
Should I remove the one on the left first?
Check topic i gave you earlier. All needed info is there.Those capacitors are the same like the ones I ordered already, right?
I'm unable to remove the flux even with 90% isopropyl alcohol...
I'm using MGChemicals 8341 and fake Amtech flux that I bought in a store (I already reported that to Amtech, and ordered genuine flux from their store)
What do you mean by "Also on this stage"?Check pins 5 and 6 if they have continuity to mid-ground pad. If you already ordered new one I would place new. Also on this stage check caps around BQ and P13USB
Now you don’t have MT with this short you might have others chips dead. Just check.What do you mean by "Also on this stage"?
Btw: my genuine Amtech flux arrived
Do you mean that I might have killed other chips by removing the M92T36?Now you don’t have MT with this short you might have others chips dead. Just check.