I have a rebug chip and i am trying to use memloader but I believe is screwing with the data comm. Is there a UF2 I can flash now that enables datacomm in RCM mode or do i still need to disconnect the D+ / D- ?
memloader fully works with nothing extra to do.I have a rebug chip and i am trying to use memloader but I believe is screwing with the data comm. Is there a UF2 I can flash now that enables datacomm in RCM mode or do i still need to disconnect the D+ / D- ?
Thanks for the input, the problem was i did a real n00b screwup and didn't want to come clean. I updated my exfat 6.2 and selected nonexfat 701 so the fw wouldn't launch after doing a bunch of stupid things including burning the fuses from 5.2 to 701 i realized all i had to do was format an sdcard to fat32 and update with the exfat. Before that i was going to try and do the manual choidujoir method but with the modchip installed i have no idea how to get into generic rcm mode so windows will recover it as apx. I was using a new pc that i hadnt done before.memloader fully works with nothing extra to do.
Check your wiring, in particular the GND cnnection.
yeahhh goodies = easter egg ^^v1.3.0 is coming!
With 8.0.0 support and some other goodies.
Might not be today though. But we will see.
Impossible to tell until you post a pic of your install. Post it in modchip thread and I`ll take a look.Hi, I just installed the RCMX86 in my switch, with joycon strap, flashed latest switchboot uf2, I have OFW7.0.1 and Emunand 6.2 with SXOS, it worked beautifully for the first day, tested dual boot OFW and CFW, but my switch won't turn on the next day after an overnight charge, I have tried all different ways like hold power for over 12 second plus some triple click tricks, none worked, the back of the switch where the modchip was fitted is a little warm to touch even when the switch is not plugged in charger, not sure if it is because of the modchip is drainning battery? I can't tell because I can't check the battery level. does this sound like a bad soldering? thanks
Hi @mattytrog , sorry for this post.....i'm Newbie my question is : i've ns-atmosphere dongle, can i use on it ? and for all the step for programming it where i can found ?
thx in advance
How to update with "SAMD Chip Update Mode" ?
Impossible to tell until you post a pic of your install. Post it in modchip thread and I`ll take a look.
Could be the USB disconnect strap causing problems but I doubt it.It eventually booted up after leaving on the charger overlight, it was like charging very very slow after the RCMX86 installed, I have v1.22 switchboot flashed, and I have connected these wires: ground, 3v, two USB pins, joycon strap and the usb disconnect strap, any idea why it is charging very slow? thanks
is version 1.3.1 online ? i cant find i? or you planning this upload for future? thanks for your work